Hi all,

I'm running into an issue using Emerson's AMS Suite. I've built a few hundred pieces of equipment on this software. I've noticed if I build a piece of equipment , say a fan but I do not know the bearing numbers. One day I stumble across the mfg. and bearing numbers I need. So I'll go into RBM wizard and add the bearing information. I will then exit/save then hit the almighty hammer. I will reload routes, even reboot the software. I will then collect data on that particular fan and those fault frequencies will not appear. In the vibration analysis tab it will actually say none available when pressing the letter "L". If I go into database setup and go to config info and all the bearing information is present, its just not being applied. I was told at one point they are in a type of queue like the software is unsure of what to do with it. I've put the frequencies in manually through the database but its much easier to use RBM wizard.

Any help would be great.  

Original Post

If you click "Edit MP" at bottom of Configuration Setup for a piece of equipment and expand the tree on the left side do you show a "+" sign next to "unassigned"? If so you need to drag those points to their shafts.

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×