Skip to main content

There was an unexpected issue forwarding you to "Twitter" for authentication. Please try again later.
×

Replies sorted oldest to newest

Dear DOMINICH.VO ,

increased noise floor with gear impact indication , are you maintaining  and changing its lubrication as per the manufacturer recommendations and grade  .

Do you mean viscosity of pumping fluid , low viscosity might have some effect but i don't think so it is the main cause   .For better understanding on this you can refer the manual and contact the support service .

RM

Thanks Dave for material. 

 the lubrication is just follow the manufacturer and no any abnormal. The spec for oil is VG100, The oil was maintaining and changing as manufacturer then i have no doubt in oil issue. 

 As see the defect mark, look like a very excessive load effect on gear and broken the teeth surface, the spectrum also shows high GMF relate to gear wear , also indicates very high load. 

then the next question is why the high load on the gear , i keep going my investigation on this way/...

 Thanks 

RM

Add Reply

×
×
×
×
Link copied to your clipboard.
×