How to change or setup the lines & Averages in CSI 2130 AMS Software.

Dear All,

Any one explain me how to change the lines & averages in  AMS machinery software. during route creation there is no option for selecting lines and averages.

After setup in the route default line is 1600.but I need only 800 lines.

so please explain me how to change the lines & Averages.

Thanks & Regards,

S.M.K

.

 

Original Post

Setup is in the AP Sets-you can modify those as you see fit. See attached. General rule of thumb that most use is FMax 80x rpm and 1600 or 3200 LOR (today's computers can handle the data load). I would advise against 800 lines as if you have a large FMax you get poor resolution that will make it difficult to determine specific frequencies during analysis.  Collect better data and you will be rewarded. I would suggest you also routinely correct a PeakVue reading on each rolling element bearing also. 

Attachments

Photos (1)
rgf12 posted:

Setup is in the AP Sets-you can modify those as you see fit. See attached. General rule of thumb that most use is FMax 80x rpm and 1600 or 3200 LOR (today's computers can handle the data load). I would advise against 800 lines as if you have a large FMax you get poor resolution that will make it difficult to determine specific frequencies during analysis.  Collect better data and you will be rewarded. I would suggest you also routinely correct a PeakVue reading on each rolling element bearing also. 

Hi rgf12,

how to get plot button box while using analysis see the attachment. Capturethank you

Attachments

Photos (1)
Files (1)
pal posted:
rgf12 posted:

Setup is in the AP Sets-you can modify those as you see fit. See attached. General rule of thumb that most use is FMax 80x rpm and 1600 or 3200 LOR (today's computers can handle the data load). I would advise against 800 lines as if you have a large FMax you get poor resolution that will make it difficult to determine specific frequencies during analysis.  Collect better data and you will be rewarded. I would suggest you also routinely correct a PeakVue reading on each rolling element bearing also. 

Hi rgf12,

how to get plot button box while using analysis see the attachment. Capturethank you

i clicked from top menu 'view' plot button box is in tick mark but still not available. which one iam missing?

1920 x 1080 resolution required to be set in windows 10.then this 'plot button box' will appear with in the monitor screen otherwise if the resolution is reduced it will go outside the monitor screen and you will not be able to see that is available.

You should setup the analysis window to show the plots you are interested in automatically. If you need to plot additional data then you can use the manual plot function. It makes reviewing masses of data points a lot easier. See attached for my setup.  

Attachments

Photos (1)

Add Reply

Likes (0)
×
×
×
×