I bought and installed a new 2hp water-cooled spindle with an inverter to run it. Inverter is https://www.valinonline.com/products/esv152n02yxb . Now, whenever I switch the spindle on it triggers my limit switches (in Mach3) and I can only reset it when the spindle is not running. Would adding a line reactor to the inverter help? Spindle and limit switch wiring is all shielded and properly grounded. Limit switches are configured as normally closed.

I’m virtually at a standstill. Any help?

Original Post

Add Reply

Post
×
×
×
×