Category II Vibration Analysts are qualified to perform basic vibration analysis using single-channel instruments according to established procedures, set-up instruments, and maintain a database of results. Minimum Experience Required : 3 years Minimum Training Hours: 38 hours 

Overview:
This course prepares attendees to perform basic machinery vibration analysis on industrial machinery using single-channel measurements, with or without triggers signals, according to established and recognized procedures. It covers basics of sensors, database and data collector setup, data collection, signal processing, fault analysis, and basics of single plane balancing. It is partial preparation for the Vibration Analyst Category II Certification Exam. The workshops and demonstrations, scheduled throughout the training course, are used to illustrate theory and applications.

Course Contents Include:
Basic Machinery Vibrations I
Period, frequency, amplitude, phase, measures, and conversions.

Basic Machinery Vibrations II
Analysis, units, natural frequencies, forcing frequencies, resonance, critical speeds, and damping.

Workshop I: Machinery Vibrations
Period, frequency and amplitude.

Workshop II: Basic Vibrations
Basic Data Collector Setup I
Measure selection; frequency spans; time, frequency, and orbital displays.
Transducers
Proximity probes, accelerometers, optical pickups, selection, location and mounting.

Workshop III: Data Acquisition
Basic Data Collector Setup II
Data sampling, triggering, window selection, resolution, dynamic range, and averaging.
Basic Analysis Techniques
Orders, spectrum analysis – direct frequency, side bands.

Workshop IV: Data Processing
Analysis of Operating Speed Faults
Orders, mass unbalance, misalignment, looseness, distortion, rubs, resonance, bearing wear, and case histories.
Gear and Bearing Analysis
Measurement methods, frequencies, analysis techniques, and case histories.
Motors, Fans, and Pumps
Basics, frequencies, techniques, and analysis.

Workshop V: Fault Analysis
Evaluation of Machine Condition
Measures, procedures, severity charts, and alarm settings.

Workshop VI: Condition Evaluation
Machine Testing
Test plans, impact testing, and acceptance testing.
Periodic Monitoring
Screening, alarm setup, frequency of measurement, trending, and reports.
Balancing
Fundamental aspects of single-plane balancing.

Workshop VII: Machine Analysis

Course Review

Training Examination on Course Content (1.5 hours)


Course Training schedule : 38 hours training period as per the guideline requirement of VI rules

Optional Certification Exam will be administered on the day AFTER the course.

INSTRUCTOR
Narendra Kumar Murthy,Chief Executive Officer Shobhan Vibration Consultancy who has vast experience in condition monitoring field and with Category III certification as per ISO 18436-2.

 
Regards
 
Narendra Kumar Murthy
Shobhan Vibration Consultancy,Bangalore
+919741955479
Original Post

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×