Skip to main content

Replies sorted oldest to newest

Why the CSI alarm did not activate while the shaft of the fan has a severe wear?

There are many possible reasons. Here are a few to consider:

1- The configured alart set point is too high.

2- The data collection configuration is not correct for this machine.

3- The measurement is not taken while the vibration is high (e.g. the readings are unstable)

4- The field data collection is not correct (e.g. the location of the sensor is insensitive to the fault).



Regards- Ali M. Al-Shurafa

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×